Two installation methods of bamboo-wood fiber integrated wallboard- Haining Longtime Industry Co., Ltd.

Bamboo-wood fiber integrated wallboard is currently the latest environmentally friendly decorative material on the market. It is not only environmentally friendly and healthy, but also has a good decorative effect. The surface is protected by UV light curing paint, which is wear-resistant, scratch-resistant, pollution-resistant, corrosion-resistant, heat-resistant and cold-resistant. Quite popular with consumers. Installation method of bamboo fiber integrated wallboard:

A. Install with wall glue

1. Cover the wall with a base layer. Commonly used are 3MM plywood, wood board, and good point is fireproof glass magnesium board. Nail them to the wall with air nails, and clean the surface of the board with sandpaper.

2. Saw the board, the bamboo fiberboard is sawn into pieces according to actual requirements.

3. Chamfering, use a chamfering machine to chamfer the four sides of the pvc ceiling panel to be installed into a 45 degree angle. According to the actual installation requirements, some only need to fall on the top and bottom sides or three sides.

4. Clean the back of the UV board, and clean the back of the UV board with sandpaper and a rag.

5. Apply universal glue or wood glue evenly on the back of the bamboo fiberboard, then stick the bamboo fiberboard on the wall evenly, and then gently hammer the bamboo fiberboard with your hands to make the bamboo fiberboard more firmly adhere to the wall. .

6. Adjust the water-adjustable joint filler, and then fill the joint filler at the intersection of two bamboo fiberboards at a 45 degree angle, fill it first, and then use the vertical angle of the plank to lightly pass the intersection of the 45 degree angle, so that the intersection is beautiful Up.

7. Clean the surface of the bamboo fiberboard, and clean the excess caulking material.

B. Aluminum alloy fixed

1. Cover the wall with a base layer, commonly used is 3MM plywood, wood board, good point is fireproof glass magnesium board, nail them to the wall with air nails.

2. Nail the foot line on the wall. Use aluminum alloy internal corners to fix the corners, and then use aluminum alloy tool strips to fix the corners. That is, nail the aluminum alloy internal corners and the aluminum alloy tool strips to the corresponding positions on the wall with nails.

3. Then there is sawing bamboo fiberboard. Saw the UV board into pieces according to the actual size required, and then smooth and clean the saw edge with sandpaper.

4. Then insert the bamboo fiberboard between the aluminum alloy internal corner and the tool strip.